Velleman-projects K8096 Assembly instructions Bedienungsanleitung

With the K8096 1-channel stepper motor card you can drive 1 stepper motor via USB, and monitor and assign actions if needed to 5 dry contacts (for exa

- 10 -Software installtionStep 7: Select “install” for installing the software.Step 8: Select the additional tasks you would like, then click “next”.S

- 11 -Driver installation20. DRIVER INSTALLATIONConnect the USB connector of the K8096 to your PC using an USB cable. With the fi rst connection, you s

- 12 -Connection diagram0 ... 30V ACex. alert switchex. limit switchINPUT1 open-collector output-+OUT21. CONNECTION DIAGRAM-+OUT+-external power suppl

- 13 -Motor demo22. MOTOR DEMOStart the program by clicking the icon on your desktop.* The fi rst channel is only active if K8096 is selected.Demo: Th

- 14 -PCB 

- 15 -VPP1VDD2GND3PGD4PGC5ROTCENNOC PSCI3KSDNG100n6C4μ75CDNG1R 01cipV5+DNGcipV5+LP20WERCS1KSV03-01+DNGDNGVBUS1USB_D-2USB_D+3GND465980CC NOC BSU2KS7004

The new Velleman Projects catalogue is now available. Download your copy here: www.vellemanprojects.euModifi cations and typographical errors reserved

ForumForumParticipate our Velleman Projects ForumSubscribing our newsletter?, visit www.vellemanprojects.eu 

- 3 -Featurescapable of driving 1 stepper motor• suited for bipolar motors• current of the motor can be adjusted (trimmer)• over current protection se

Supply voltage (V) - led voltage (V)required current (A)= series resistance (ohms)required current (A)= series resistance (ohms)Required resistor powe

assembly hints1. Assembly (Skipping this can lead to troubles ! )Ok, so we have your attention. These hints will help you to make this project succes

- 6 -DO NOT BLINDLY FOLLOW THE ORDER OF THE COMPONENTS ONTO THE TAPE. ALWAYS CHECK THEIR VALUE ON THE PARTS LIST! 

- 7 -ConstructionR1 : 10Ω (1 - 0 - 0 - B) R2 : 10KΩ (1 - 0 - 3 - B) R3 : 10KΩ (1 - 0 - 3 - B) R4 : 56KΩ (5 - 6 - 3 - B) R5 : 56KΩ (5 - 6 - 3

- 8 -ConstructionX1 : 12MHz X. . . . .C...Board to wire 10Watch the polarity!Watch the polarity!C2 : 100μF C3 : 330μF C4 : 100μF C5 : 4,7μF C11 :

- 9 -Software installation19. SOFTWARE INSTALLATIONAfter assembly of the circuit, it is now time to install the software. For software, visit www.vell